How to make a lightsaber in 15 minutes

Here’s how to make your own lightsaber in about 15 minutes.

We don’t want to bore you with the whole thing.

If you’re still confused, we’ve put together a video that should get your mind blown.

It’s the best thing you’ll see on TV this week, and we know that a few of you have a bit of an interest in this topic.

Here’s what you need:The simplest way to do it is to buy a lightsaber kit, which costs around $300.

You’ll then need to buy some parts and assemble the lightsaber from scratch.

You can do this online, or by visiting a shop like eBay or Amazon.

The main thing you need to know is how to turn your new weapon into a lightsaber.

We’re going to show you how.

Step 1: Cut out a lightsaber’s baseFirst, you’ll need to cut out a “base” of metal that’s about 10mm wide.

You should also make sure you get the right kind of metal so it fits in your weapon’s barrel.

To cut out your base, hold the weapon in your left hand and push it into the centre of the table, as shown in the image below.

It should be about 10 mm away from your palm.

Step 2: Drill a hole in the baseStep 2a: Drill holes for the trigger pieceNow, it’s time to make the trigger.

Cut the metal off the base, as seen in the picture below.

Then, make a small hole in one side and drill a hole at the other, as pictured below.

Step 3: Screw the trigger into the baseNow, you need two screws, one at each end of the base.

Drill the two holes and screw the trigger back into the weapon.

You’re done.

Now, attach the trigger to the barrel, as you see in the below picture.

Step 4: Light the saberNow, all you need is a lightsaber to light it up.

Just like with the rest of your kit, we’re going the whole hog here.

You don’t need to make an entire light saber, as the ones you see above have all of the lights.

Just the right amount of light, enough to get you into a trance.

Step 5: Aim your lightsaber at the targetAs soon as you’ve got the light sabers pointed at the targets, turn your weapon to your right and shoot it at them.

If they’re light enough to hit you, that’s great.

However, you can use the lights in the other parts of your weapon as well, as we’ll explain later.

Step 6: Use your lightsaber to destroy enemiesThe same principle applies to destroying enemies, as well.

Simply shoot the lightsaber in the direction you want to hit, and hit the target.

You want the target to be a dark area, so hit it with the light.

Step 7: Now you have the lightsaberYou now have your very own lightsaber, and now it’s ready to be used in battle.

Here’s what to do next.

Step 8: Charge up your saberOnce you’ve done your best to hit your target with the lights, you have to charge up your lightsaber.

Simply hold down the trigger button for a few seconds, then hold it down for a second.

Once you’ve charged up the sabers speed, release it, and then hold down for about 10 seconds to make sure your lightsaber is fully charged.

You now have the chance to do this several times until you’ve hit your targets.

Step 9: Finish the fightIf you’ve managed to hit the targets with your lightsaber, then you have one last challenge to tackle: finish the fight.

Once the fight is over, your sabers lightsaber will be out of charge and you can’t charge it back in.

You’ve also lost a point of power for that round, so you’ll have to do the whole job again.

Back To Top